Closed Overhead Through Spray To Waste Batch Booths
poedercoatcabine toz boya kabini Salutan serbuk gerai
Specification:
1.Spray booth:
1.inner size: W1.4*H1.8*L1m
2.Booth board: SPCC/= 1.5mm Bending and forming
3.Under frame:4 # square tube
4.Recycle Filters:325*900mm- 2pcs
5.fan motor: 3.5KW, 1pcs
2.Technical data
| Model |
COLO-S-2152 |
| Booth Type |
Closed-drive-thru |
| Operator dimensions |
1400width x 1800 height x 1000 depth |
| Overall dimensions |
2500width x 2300 height x 1500 depth |
| Weight |
450kg |
| Power supply |
Electric |
| Nominal power |
3.5kW |
| Voltage |
380V |
| Frequency |
50-60Hz |
| Filters |
Polyester |
| Filters count |
2 |
| Filters hang type |
easy for change |
| Filter cleaning system |
Pneumatic |
| Air consumption |
10,200m3/h |
| Warranty |
12 months |
3.Advantage:
1.applied for small workpiece:car wheel hub etc
2.Working with manual gun
3.Smooth interior, easy to clean.
4.the control and monitoring of each active component can be individually regulated, ensuring better service life for pneumatics and electrics.
5.Short powder cycle, safeguards the powder.
6.Energy saving air circulation, the extracted air is fed back into the paint shop.
Also economical in mixed powder mode for individual colours.
4.Replacing the filter cartridges Replacing the filter cartridges
Procedure for replacing the filter cartridges
If a filter cartridge is damaged, but the damage can not be found, then the complete filter
cartridges set must be replaced. The access to the filter
cartridges takes place from the rear of the booth
| Dismantling: |
|
| 1.fix the screw on the top |
| 2.Hold the cartridge with both hands, so that the filter's six ears for quick release cover six corresponding gap |
| 3.His hands up top, while the rubber ring as a fulcrum to sixty degrees clockwise |
| 4.Check the filter is fully embedded in the quick release cover, hand gently pulled the filter is securely |
Operation:
| 1.press bottom 1 ,make the power on |
| 2,Press ↑or↓ ,make the display screen display like this |
| 3,Press F4 ,then into the booth control interface like this |
| 4,Press F6,then the fan will on ,like this |
When you want to stop the work, please press F6 ,make the fan off, like this
Then press the bottom 1 to make the power off.
In the side of the booth have the switch to control the light lamp
More details
Contact:
Miss Sonne Xie
Audited Supplier 
){kind=link}