Automatic Powder Coating Production Line
Loaded into the powder coating production line process: Pre-treatment, powder coating, heat curing.
Coating production line production of pre-treatment section
Pre-treatment process simple and automatic with manual pre-treatment process, which in turn points and automatic sprinkler spray dip two processes. The work must be carried out before the powder surface treatment to the oil to rust. As used in this section are more liquid, there are rust, degreasers, table transfers, phosphate and the
Powder coating production organization
For small quantities of parts, in general, manual powder spraying device, and for high-volume parts, generally using a manual or automatic spray device. Whether manual or automatic dusting powder and protect the quality is very important. To ensure that the work being sprayed with pink uniform, consistent thickness, thin spray to prevent leakage spray, wipe off the other defects
Powder coating Curing process of coating production lines
This process should pay attention to matters include: Spray a good piece, if small quantities of single-piece production, into curing furnace attention to prevent collision off the powder, if Cafen phenomenon should promptly fill spray powder. When the baking process and strict temperature and time control, and effectively pay attention to prevent chromatic aberration, over drying or curing time is too short resulting in insufficient.
For automatic delivery of large quantities of artifacts, bake the same before proceeding to carefully check whether the leak spray, gushing or local Cafen phenomena, such as found substandard parts, should be better off to prevent access to bake, remove as much as possible re-spray. As a result of an individual piece of thin spray failed, after curing the bake curing can be re-sprayed again.
The so-called painting refers to the metal and non-metallic protective layer covering the surface or decorative layer. Coating line through the development process by hand to the production line, automatic production lines, increasing the degree of automation, the application of coating production lines and more widely
Audited Supplier 
){kind=link}