Drive-through Powder Coating Spray Booth Loading To Kenya
equipo de pintura malowanie proszkowe stoisko cabina di verniciatura a polvere
Industrial Automatic Spray Booths easy operation with good powder recovery systems.
our customer of Kenya buy 1 Drive-through powder spray booth,curing oven 1pcs,powder sieve etc.
Booth size and color can be designed by the requst.
1.Specification:
1).Spray booth:
1.inner size: 620width x 1500 height x 2920 depth
2.Booth board: SPCC/= 1.5mm Bending and forming
3.Under frame:4 # square tube
4.Recycle Filters:325*900mm- 3pcs
5.fan motor: 3.5KW, 1pcs
6.manual powder coating gun ,1pcs
2.)Technical data
| Model |
COLO-S-3212 |
| Booth Type |
drive-thru |
| Operator dimensions |
620width x 1500 height x 2920 depth (2PCS) |
| Overall dimensions |
1200width x 2033 height x 3000 depth |
| Weight |
500kg |
| Power supply |
Electric |
| Nominal power |
3.5kW |
| Voltage |
380V |
| Frequency |
50-60Hz |
| Filters |
Polyester |
| Filters count |
3 |
| Filters hang type |
easy for change |
| Filter cleaning system |
Pneumatic |
| Warranty |
12 months |
3).Advantage:
1.applied for thin workpiece.
2.Working with manual gun
3.Smooth interior, easy to clean.
4.the control and monitoring of each active component can be individually regulated, ensuring better service life for pneumatics and electrics.
5.Short powder cycle, safeguards the powder.
6.Energy saving air circulation, the extracted air is fed back into the paint shop.
Also economical in mixed powder mode for individual colours.
4).Replacing the filter cartridges Replacing the filter cartridges
Procedure for replacing the filter cartridges
If a filter cartridge is damaged, but the damage can not be found, then the complete filter
cartridges set must be replaced. The access to the filter
cartridges takes place from the rear of the booth
| Dismantling: |
|
| 1.fix the screw on the top |
| 2.Hold the cartridge with both hands, so that the filter's six ears for quick release cover six corresponding gap |
| 3.His hands up top, while the rubber ring as a fulcrum to sixty degrees clockwise |
| 4.Check the filter is fully embedded in the quick release cover, hand gently pulled the filter is securely |
5).Control cabinet-Bottom:
1,power on/off
2,hopper go up/go down
3, emergency stop
PLC Controller Operation:
| 1.press bottom 1 ,make the power on |
| 2,Press ↑or↓ ,make the display screen display like this |
| 3,Press F4 ,then into the booth control interface like this |
| 4,Press F6,then the fan will on ,like this |
When you want to stop the work, please press F6 ,make the fan off, like this
Then press the bottom 1 to make the power off.
In the side of the booth have the switch to control the light lamp
Audited Supplier 
){kind=link}
){kind=link}